Table of Contents
Advertisement
3.
Always turn off the Sander, remove the Switch Key (21), and unplug the unit from
its electrical outlet before performing any inspection, maintenance, or cleaning
procedures.
4.
Never leave the Sander unattended when it is plugged into an electrical outlet.
Make sure to unplug the Sander from its electrical outlet and remove the Switch Key
(21) before leaving the area.
5.
Store idle equipment. When not in use, tools and equipment should be stored in a dry
location to inhibit rust. Always lock up tools and equipment, and keep out of reach of
children.
6.
Industrial applications must follow OSHA requirements.
7.
Reduce the risk of accidental starting. Make sure the Power Switch is in its "OFF"
position before plugging the Power Cord into a 120 volt, grounded, electrical outlet.
8.
Before sanding, turn on the Sander and check for excessively loose Sanding
Belt or Disc. If necessary, turn off the Sander and correct the problem before using.
9.
Always keep hands and fingers as far away as possible from the moving parts of
the Sander.
10.
Use the right tools for the job. Do not attempt to force a small tool or attachment to
do the work of a larger industrial tool or attachment. There are certain applications for
which this tool was designed. It will do the job better and more safely at the rate for
which it was intended. Do not modify this tool, and do not use this tool for a purpose for
which it was not intended.
11.
Allow the Sanding Belt and Sanding Disc to spin up to full speed before feeding
a workpiece into them. When turning off the Sander, allow the Sanding Belt and
Sanding Disc to slow down and stop on their own. Do not press against the Belt or Disc
to stop them.
12.
Feed the workpiece into the Sanding Belt and Sanding Disc gradually and into
the direction of rotation. Do not attempt to force the Sander to remove material faster
than it was designed to cut.
13.
When replacing the Sanding Belt, make sure the Belt has a minimum 2000 FPM
rating. When replacing the Sanding Disc, make sure the Disc has a minimum
3500 RPM rating.
14.
To avoid damage to the Sander and personal injury, allow 1/16" clearance between
the Sanding Belt and Backstop and 1/16" clearance between the Sanding Disc
and Worktable.
15.
When sanding a large workpiece, make sure its entire length is properly supported.
16.
Never attempt to remove material stuck in the moving parts of the Sander while
it is plugged in or running.
17.
WARNING! Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known (to the State of California) to
cause cancer, birth defects or other reproductive harm. Some examples of these
SKU 38123
For technical questions, please call 1-800-444-3353.
Page 5
Hide quick links:
Advertisement
Table of Contents
