Use Gps Data; Landmarks; Create A Landmark; Edit Landmarks - Nokia E51 User Manual

Select Navigation to view navigating information to your
trip destination, Position
about your current location, or
travelling information such as the distance and duration
you have travelled, and your average and maximum
speeds.
The application must receive positioning information
from at least three satellites to be used as a travelling aid.
The trip meter has limited accuracy, and rounding errors
may occur. Accuracy can also be affected by availability
and quality of GPS signals.

Use GPS data

To check the signal strength of the satellites that provide
the positioning information necessary for navigation,
open any of the three views and select
Satellite status.
To set a landmark or location as the destination of your
trip, select Navigation
>
You can also enter the destination latitude and longitude
coordinates.
To remove the destination set for your trip, select
Navigation Options
>
To save your current position as a landmark, select
Navigation or Position, and
To activate the trip meter, select
Start. To stop the trip meter, select
To reset all fields and start calculating the trip again, select
Trip dist. Options > Restart.
>
to view positioning information
Trip dist. to view your
Options
>
Options Set destination.
>
Stop navigation.
>
Options Save position.
>
Trip dist. Options
>
Options > Stop.
To change the measuring system in use, select
Settings Measurement system
>
Imperial.
To enter the altitude calibration to correct the altitude
received from the positioning satellites, select
Settings Altitude
>

Landmarks

Select Menu Tools
>
Landmarks are coordinates to geographic locations that
you can save to your device for later use in different
location-based services. You can create landmarks using a
Bluetooth GPS accessory or network (network service).

Create a landmark

To create a landmark, select
Select Current position
latitude and longitude coordinates of your current
location, Use map to select the location from a map, or
Enter manually to fill in necessary location information
such as a name, category, address, latitude, longitude, and
altitude.
To show the landmark on the map, select
Show on map.
>

Edit landmarks

To edit a landmark, select
from the following:
Metric
>
calibration.
> Landmarks.
Options New landmark.
>
to make a network request for the
Options
Options Edit Options
> >
Options
>
or
Options
>
>
and
87