Turning The Tv On/Off; Supplying Electric Power To The Antenna; Initial Auto Installation; Checking Signal Information - Sharp Aquos LC-40LE530X Operation Manual

Turning the TV on/off

Turning on/off the power
• To turn on the power
Press POWER on the TV (After a few seconds, an image
appears with sound).
• To turn off the power
Switch it off by pressing POWER on the TV.
Standby mode
• To standby mode
If the TV is switched on, you can switch it to standby by
pressing POWER on the remote control.
• Switching on from standby
From standby, press POWER on the remote control.
NOTE
• If you are not going to use this TV for a long period of time, be
sure to remove the AC cord from the AC outlet.
• Minor power is consumed when the unit is in standby mode.
Supplying electric power to the
antenna
When you set-up the DTV antenna for the first time, or
connect the antenna to a community antenna, you need
to proceed to set the antenna by following this manual.
1
Press DTV to access DTV mode.
2
Press MENU and the MENU screen displays.
3
Press c/d to select "Setup".
4
Press a/b to select "Digital programme setup"
and then press ENTER.
5
Press a/b to select "Antenna power" and then
press ENTER.
6
Press c/d to select "Yes" and then press
ENTER.
Selected item
Select "Yes" when your antenna is set-up
Yes
and connected independently.
Select "No" when you do not need to
supply voltage to your antenna, i.e. when
No your antenna is connected to a community
antenna (The factory default setting of this
function is "No").

Initial auto installation

When the TV powers on for the first time after purchase,
the initial auto installation wizard appears. Follow the
menus and make the necessary settings one after
another.
1
Press POWER on the TV.
• The initial auto installation wizard appears.
2
Press c/d to select "HOME" or "STORE", and
then press ENTER.
Press c/d to select your country channels listed
on the screen, and then press ENTER.
Press a/b/c/d to select "DTV", "ATV" or "ATV
+ DTV", and then press ENTER.
Press a/b to select the desired sound system,
and then press ENTER.
• Sound system is selectable when the signal search is set
to "ATV" or "ATV + DTV" mode only.
• Auto installation will be executed.
• You do not need to do anything during the auto search.
• HOME: "STANDARD" will be the default value for the "AV
mode" setting.
• STORE: "DYNAMIC (FIXED)" will be the default value for
the "AV mode" setting. If the "AV mode" is changed, the
TV will automatically switch back to "DYNAMIC (FIXED)"
when there is no further change to TV setting for 30
minutes.
• To change the STORE mode to HOME mode, please
refer to page 14 to reset the unit.

Checking Signal information

If you install a DVB-T antenna for the first time or relocate
it, you should adjust the alignment of the antenna to
receive a good reception while checking the antenna
setup screen.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Digital programme setup",
and then press ENTER.
Description
9