Table of Contents
Advertisement
8.
When you are completely finished or
are stopping for the day, disconnect
and empty the Plastic Hopper. Flush
the system with fresh cold water.
Rinse and clean the Plastic Hop-
per and the Gun Body and let both
dry completely before storing inside,
away from children.
9.
If the tool requires more force to
accomplish the task, verify that the
tool receives sufficient, unobstructed
airflow (CFM) and increase the
pressure (PSI) output of the regulator
up to the maximum air pressure
rating of this tool.
CAUTION! TO PREVENT TOOL
AND ACCESSORY FAILURE,
RESULTING IN INJURY:
Do not exceed the tool's maximum
air pressure rating.
If the tool still does not have sufficient
force at maximum pressure and
sufficient airflow, then a larger tool
may be required.
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
SKU 66103
For technical questions, please call 1-800-444-3353.
FROM ACCIDENTAL
OPERATION:
Turn off the tool, detach the
air supply, safely discharge
any residual air pressure in
the tool, and release the Gun
Trigger before performing any
inspection, maintenance,
nozzle changes, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
Note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the air-operated tool.
1.
Daily - Air Supply Maintenance:
Every day, perform maintenance on
the air supply according to the com-
ponent manufacturers' instructions.
Performing routine maintenance on
the air supply will allow the tool to
operate more safely and will also
reduce wear on the tool.
TO PREVENT
SERIOUS INJURY
Page 10
Hide quick links:
Advertisement
Table of Contents
