Setting Date/Time (Clock Set) - Panasonic LUMIX DMC-LX1GC Operating Instructions Manual

Setting Date/Time (Clock Set)

n Initial setting
The clock is not set when the camera is
shipped. When you turn the camera on, the
following screen appears.
• Take the lens cap off before setting the
date and time.
• Press the [MENU] button, the screen
shown in step 1 appears.
• The setting screen disappears in about 5
seconds. Switch the unit back on to show
the above screen again. Alternatively,
press the [MENU] button to show the
menu screen (P22), select [CLOCK SET]
on page 2/4 of the setup menu, and do
steps 1 and 2.
1
Set date and time.
CLOCK SET
:
0 00
D M Y
SELECT
• w/ q : Select the desired item.
• e/ r : Set date and time.
. .
1 JAN 2005
SET EXIT
MENU
Preparation
2
Select [D/M/Y], [M/D/Y] or [Y/M/D].
CLOCK SET
10 : 00
SELECT
• Close the menu by pressing the [MENU]
button 2 times after finishing the setting.
• Check if the clock setting is correct, after
turning the camera off and on.
• When a fully charged battery has been
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed. (The storing time may be
shorter if the battery is not charged
sufficiently.)
If more than 3 months has passed, the
clock setting will be lost. In this case, set
the clock again.
• You can set the year from 2000 to 2099.
The 24-hour system is used.
• If you do not set the date, the date cannot
be printed when you go to a photo studio
for digital printing.
• For the date print setting, refer to P95.
20. DEC. 2005
D M Y
SET EXIT
MENU
VQT0S36
21