Jumper Options; Rear Connectors - SoundCraft MH2 User Manual

28
cleared with a single button press at the master section. The solo buttons also feature automatic
momentary operation, by pressing and holding for more than 0.5 sec.

Jumper Options

Function Options
Direct switch UP = Pre-fade DOWN = Post fade
operation UP = Pre-filter, DOWN= Post-EQ.
Input and Output Levels
MIC INPUT (electronically balanced)
Gain range +15dB to +60dB (-5dB to +40dB with -20 switch)
maximum input level
input impedance
LINE INPUT (electronically balanced)
Gain range
maximum input level
input impedance
INSERT SEND (impedance balanced)
nominal level
maximum output level +21dBu into 2kohms
output impedance
INSERT RETURN (electronically balanced)
sensitivity
maximum input level
input impedance
DIR OUTPUT (impedance balanced)
nominal level
maximum output level +21dBu into 2kohms
output impedance

Rear Connectors

MIC INPUT (3 pin female XLR)
Pin 1 Ground
Pin 2 Signal Hot
Pin 3 Signal Cold
LINE INPUT (1/4" TSR Jack)
Tip Signal Hot
Ring Signal Cold
Sleeve Ground
INSERT RETURN (1/4" TSR Jack)
Tip Signal Hot
Ring Signal Cold
Sleeve Ground
INSERT SEND & DIRECT OUTPUT (1/4" TSR Jack)
Tip Signal Hot
Ring Cold (75ohm to ground)
Sleeve Ground
+26dBu
2kohms
-5dB to +40dB
+26dBu
10kohm
0dBu
<75ohms
0dBu
+26dBu
>10kohms
0dBu
<75ohms
Default
<<<<<<