Panasonic LUMIX DMC-FX550 Operating Instructions Manual page 32

[FORMAT]
•
Use a battery with sufficient battery power or the AC adaptor (optional) and DC coupler
(optional) when formatting. Do not turn the camera off during formatting.
•
If a card has been inserted, only the card is formatted. To format the built-in memory, remove
the card.
•
If the card has been formatted on a PC or other equipment, format it on the camera again.
•
It may take longer to format the built-in memory than the card.
•
If you cannot format, contact the dealer or your nearest Service Centre.
[CALIBRATION]
•
Calibration is not done if correct position is not touched. Touch the [ i ] mark again.
~ [LANGUAGE]
•
If you set a different language by mistake, select [~] from the menu icons to set the desired
language.
[DEMO MODE]
DEMO
•
In playback mode, [JITTER, SUBJ. MOVE DEMO.] cannot be displayed.
•
Press [DISPLAY] to close [JITTER, SUBJ. MOVE DEMO.]. Press [MENU/SET] to close
[AUTO DEMO].
•
[JITTER, SUBJ. MOVE DEMO.] is an approximation.
•
[AUTO DEMO] has no TV output capability even when it is in playback mode.
Preparation
The built-in memory or card is formatted. Formatting
irretrievably deletes all the data so check the data carefully
before formatting.
Adjust the position of the touch panel if a different thing gets
selected from what you touched or touch operation does not
respond.
1
Press [MENU/SET].
2
Touch the orange [r] mark
displayed on the screen in
order with the stylus pen
(supplied) (5 places).
•
A message is displayed once the
position is set.
3 Press [MENU/SET] to finish.
Set the language displayed on the screen.
The camera automatically detects jitter and the movement of the
subject and displays these on the indicator. ([JITTER, SUBJ.
MOVE DEMO.])
The camera's features are displayed as slide shows. ([AUTO
DEMO])
[JITTER, SUBJ. MOVE DEMO.]
A Jitter detection demonstration
B Movement detection demonstration
[AUTO DEMO]:
[OFF]
[ON]
- 32 -
A
B