Identification Of Controls; Front Panel - NAD C 546BEE Owner's Manual

Hide thumbs Also See for C 546BEE:

Service manual (60 pages)

Table Of Contents

Table of Contents

C 546BEE

1 STANDBY BUTTON: Press this button to switch ON the C 546BEE. The

Standby LED indicator will turn from amber to blue and illuminate the

Vacuum Fluorescent Display (VFD). Pressing the Standby button again

turns the unit back to standby mode.

The C 546BEE can also be switched ON from standby mode by pressing

[PLAY/PAUSE/SKIP] knob on the front panel. Pressing CD 9's [ON], [ ] or

[

] buttons will also wake up the C 546BEE from standby mode.

If the disc tray is open and the Standby button is pressed, the disc tray

will draw close and the C 546BEE goes to standby mode.

NOTE

The C 546BEE will wake up from standby mode at the same SOURCE

setting it was in prior to being switched OFF to standby mode.

2 STANDBY LED: This indicator will light up amber when the C 546BEE

is at standby mode. When the C 546BEE is at ON state, this indicator will

illuminate blue.

3 DISC TRAY: With the disc tray open, insert a CD or other compatible

media disc face down onto the tray. Place the disc in the drawer,

centered in the smaller circular recess, with its label facing UP.

"Disc error" appears on the C 546BEE VFD if the disc is placed upside

down. "No Disc" appears on the C 546BEE VFD if there is no disc loaded.

NOTE

This player is not designed to accommodate neither a "damping disc"

placed on a CD nor two CDs stacked together. It plays audio CDs, but not

discs identified as CD-V, DVD, CD-I, CD-ROM or PHOTO CD.

the item "CD-R AND CD-RW AUDIO DISCS" at the "USING THE C 546BEE –

CD MODE" section of the "OPERATION" page.

4 STOP/OPEN: This dual-function button alternates between stopping

playback and opening/closing the disc tray. Press this button to open

and close the disc tray. Pressing this button during disc playback will

cause the C 546BEE to stop playback; press again to open the disc tray.

Press [STOP/OPEN] button once to stop playback and re-set the

pickup to the beginning of the disc. The display reverts to showing

the number of tracks and total playing time on the disc; for WMA/MP3

files, the display will revert to total number of files. If the C 546BEE was

programmed to play a selection of tracks, the program will be retained

in the player's memory. Pressing [STOP/OPEN] twice at program mode

will delete the program.

Repeat and Random playback mode can be disengaged by pressing

the [STOP/OPEN] button.

Pressing the [STOP/OPEN] button will also switch ON the C 546BEE from

standby mode.

5 SOURCE: Toggle this button to select through the following SOURCE

modes - CD and USB. A corresponding icon (CD or USB) will illuminate

in the VFD as the applicable SOURCE is selected or comes up during

selection.

Refer also to