Introduction; Getting Started; Unpacking And Setup; Quick Start - NAD C 546BEE Owner's Manual

INTRODUCTION

GETTING STARTED

UNPACKING AND SETUP

WHAT'S IN THE BOX
Packed with your C 546BEE you will find:
• An audio cable connector
• The CD 9 remote control with two AA batteries
• A detachable AC power cord
• This owner's manual on CD-ROM
SAVE THE PACKAGING
Please save the box and all of the packaging in which your C 546BEE
arrived. Should you move or otherwise need to transport your C 546BEE,
this is by far the safest container in which to do so. We've seen too many
otherwise perfect components damaged in transit for lack of a proper
shipping carton, so please: Save that box!
CHOOSING A LOCATION
Choose a location that is well ventilated (with at least several inches to
both sides and behind), and that will provide a clear line of sight, within
23 feet/7 meters, between the C 546BEE's front panel and your primary
listening/viewing position. This will ensure reliable infrared remote control
communications. The C 546BEE generates a modest amount of heat, but
nothing that should trouble adjacent components. It is perfectly possible to
stack the C 546BEE on top of other components.
NOTE ON INSTALLATION
IMPORTANT! Install the C 546BEE Compact Disc player on a level, vibration-
free surface. Severe vibration or operation in a tilted position may cause
the player to mis-track. The player may be stacked with other stereo
components, as long as there is adequate ventilation around it. If the
C 546BEE is placed in close proximity to a radio tuner (AM or FM), a VCR or
a television set, the operation of its digital circuits may produce static that
would interfere with reception of weak broadcast signals. If this occurs,
move the C 546BEE away from other devices or switch it off when viewing
or listening to broadcasts.
6

QUICK START

In case you simply cannot wait to experience the performance of your new
NAD C 546BEE, we provide the following "Quick Start" instructions to get
you underway.
Please make all the connections to your C 546BEE with the unit unplugged.
It is also advisable to power down or unplug all associated components
while making or breaking any signal or AC power connections.
PLAY A CD
1 Connect a twin RCA-to-RCA lead from the L (left) and R (right) Line
Output jacks to the corresponding CD inputs on your amplifier.
2 Connect the AC cord to the C 546BEE's AC Mains input and then plug
into an AC outlet. The Standby LED indicator embedded around the
bezel of the STANDBY button will illuminate amber.
3 Press the STANDBY button to turn ON the player. The Standby LED
indicator will turn from amber to blue and illuminate the Vacuum
Fluorescent Display (VFD).
4 Press [STOP/OPEN] to open the disc drawer.
5 Place a CD, label side up, in the tray's circular recess. Be certain that the
disc is centered within the recess.
6 Press [PLAY/PAUSE/SKIP]. The drawer closes automatically, and the disc
begins to play.
7 At any time you may rotate the [PLAY/PAUSE/SKIP] knob to select
different tracks on the disc.
8 Press [PLAY/PAUSE/SKIP] if you want to stop play temporarily while
keeping the pickup at its current position on the disc.
Press [PLAY/PAUSE/SKIP] again when you want to resume playback.
Press [STOP/OPEN] if you want to end play and reset the pickup to the
beginning of the disc.