Preparing The Remote Control; Demo Function; Handling Of The Disc Trays And Discs - Panasonic SC-AK270 Operating Instructions Manual

Preparing the remote control

Insert so the
poles (+ and –)
match those in the
remote control.

DEMO function

Handling of the disc trays and discs

Not doing the following will cause damage to the unit.
Removing the mains plug
Press [y/I] to turn off the unit and remove the mains plug only after all the displays have disappeared.
Inserting a disc
• Place the disc correctly with the label facing up as shown in the diagram.
• Insert one disc into the tray.
6
RQT8043
AA/R6/LR6
- 7 STOP, –DEMO
Do not:
• mix old and new batteries.
• use different types of batteries at the same time.
• take apart or short circuit the batteries.
• attempt to recharge alkaline or manganese batteries.
• use batteries if the covering has been peeled off.
Mishandling of batteries in the remote control can cause electrolyte
leakage, which may cause a fi re.
Remove the batteries if the remote control is not going to be used for a long
period of time. Store in a cool, dark place.
■ Use
Aim at the remote control signal sensor (\ page 7), avoiding obstacles, at a
maximum range of 7 m directly in front of the unit.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
• Do not use rechargeable type batteries.
• Do not heat or expose to fl ame.
• Do not leave the battery(ies) in an automobile exposed to direct sunlight
for a long period of time with doors and windows closed.
When the unit is fi rst plugged in, a demonstration of its functions may be
shown on the display.
If the demo setting is off, you can show a demonstration by selecting "DEMO
ON".
Press and hold [- 7 STOP, –DEMO] on the main unit.
The display changes each time you press and hold the button.
NO DEMO (off) DEMO ON (on)
While in standby mode, select "NO DEMO" to reduce power consumption.
Note:
DEMO function cannot be turned on when DIMMER is on.
Tray caution
• Always press [0, OPEN/CLOSE] to insert or remove
a disc.
• Do not push or pull out the tray by hand as this will
cause an accident.