Table of Contents
Advertisement
G
F
E N E R A L
U N C T I O N S
Deleting a Call Select Number
1. In the Call Select menu, select Delete CLI.
Note: If there is a number stored in the first location, the number is
displayed.
2. Press
or
key to select a desired number.
3. When the desired number is displayed, press
beep, your phone returns to the Standby mode.
Turning the Feature On/Off
1. In the Standby mode, press and hold
2. If the feature has been turned off, the feature is turned on, or vice
versa. With a beep, the LCD window displays Call Select On (or Off)
briefly and then returns to the Standby mode.
3. If the feature is turned on, the
window. If it is turned off, the icon disappears.
With this feature on, if you get a call from a unregistered telephone,
your phone will blink the
lamp without ringing.
Notes:
• Even if you are not subscribed the CLI service, you can turn this
feature on, but it will not operate.
• If your telephone system does not support CLI service, do not turn the
Call Select feature on, for the phone will not ring with this feature on.
26
key. After one
key.
icon appears steadily in the LCD
Battery Level Indicator
A
icon is continuously displayed in the upper line of the LCD
window. The
icon shows the level of your battery. The more bars
you see, the more power you have left.
H S ( 1 )
S A M S U N G
Flat
When the battery is weak and a few minutes of talk time remain, you
will hear a warning tone and the
icon blinks.
When the battery becomes too weak for the phone to operate, the
handset will automatically turn off. Place the handset on the base unit to
charge the handset battery.
Out of Range Indicator
Your phone indicates the received signal strength through the strength
icon. The more bars you see, the stronger the signal is. If the handset is
too far from the base unit and the handset cannot properly engage the
telephone line, the
icon blinks in the LCD window.
Signal
Strength Icon
H S ( 1 )
B S ( 1 )
S A M S U N G
If you move out of range during a call, the telephone line might be
disconnected and the handset returns to the Standby mode. Check if the
icon blinks in the LCD window. If so, move the handset closer to the
base unit.
G
F
E N E R A L
U N C T I O N S
B S ( 1 )
Full
27
Advertisement
Table of Contents
