Table of Contents
Advertisement
Using the Battery
Please refer to the following instructions when running the computer on
battery power without connecting the AC power.
This computer uses smart rechargeable Lithium-Ion (Li-Ion) battery.
C
a
C
a
Ejecting and Attaching Battery
1. Shutdown system and close LCD.
2. Put the computer upside down.
3. Pull the two battery latches outward(
C
a
C
a
4. To install the battery again, slide the battery into the system as below. The battery
C
a
C
a
Manual
5-4
u
t
i
o
n
u
t
i
o
n
Please read the instructions on the battery before use.
Please refer to the system operation environment (Page A-2) of this manual and oper-
ate and store the battery at room temperature.
u
t
i
o
n
u
t
i
o
n
In X10 plus model, slide left battery latch outward(
while holding the right battery latch outward(
latch moves inward, and fixes the battery automatically.
u
t
i
o
n
u
t
i
o
n
Using the bridge battery
Your computer has a bridge battery, which supplies power for a short time even when
there is no battery installed. Thus you can exchange a battery in standby mode, with-
out turning the computer completely off. When you are exchanging the battery in
standby mode, exchange in 3 minutes.(Only for X30 model)
), then remove the battery.
), then remove the battery
).
N
o
t
e
N
o
t
e
For X10 plus model, slide the left
battery latch to the right to fix the
battery.
battery latch
battery latch
Hide quick links:
Advertisement
Table of Contents
