Table of Contents
Advertisement
2.
Acquire a 1/4" NPT air fitting (not supplied) and screw into the Air Inlet fitting.
Tighten with a wrench.
3.
Attach a quick-coupler (not supplied) to the air fitting if desired. This allows
quick exchange of the Air Hose to other air tools.
4.
Once the air compressor is off, connect the Air Hose to the Air Inlet Coupling.
This air tool requires lubrication during operation. For best results, it is recom-
mended to have an oiler and water filter in line with the air supply as shown. This
will extend the life of the tool.
Attaching/Changing the Wheel Accessory
1.
Fit the U-shaped end of
the Stop Spanner [33]
around the Gear Shaft
[6] and hold in place to
prevent the Shaft from
spinning. Insert the two
prongs on the end of the
Disc Spanner [34] into the
corresponding holes in the
Disc Nut [1] and turn your
wrist to unscrew the Disc
Nut. See Fig. A, right.
2.
Slide the grinding wheel onto the Shaft.
3.
Replace the Disc Nut and tighten using the Stop Spanner and Disc Spanner.
DANGER! Grinding wheel used must be rated at 11,000 RPM or higher.
1.
Always wear ANSI approved impact safety goggles when setting up and
using this tool.
2.
Tighten all work pieces to your work surface with a clamp or vise so that both
of your hands are free to operate the Grinder.
3.
Screw the Handle [35] into the threaded inlet on the side of the Angle
Housing [13] as shown in the Assembly Diagram on Page 8.
4.
Set the Air Compressor's pressure regulator to 90 PSI. Connect the Grinder
to the Air Compressor's hose.
5.
Check to be sure all attachments are secure before turning on the tool.
SKU 95504
Operation
Page 6
Fig. A
REV 09l
Advertisement
Table of Contents
