Maintenance And Troubleshooting - Central Pneumatic 95504 Assembly And Operating Instructions Manual

4” air angle grinder

Hide thumbs Also See for 95504:

Assembly and operating instructions manual (10 pages)

Table Of Contents

Table of Contents

Adjust the Wheel Guard so that it provides a shield between you (the user)

and the material you are working on.

place at all times when using the Angle Grinder.

Grip the Handle [35] with your left hand and the Housing [25] with your right

hand. Depress the Lever [31] with your right hand to turn the tool on. Allow

the motor to reach its full speed before grinding. Make sure the grinding

wheel is rotating evenly and all parts appear to be working properly. Always

maintain a firm grip with both hands when operating this tool.

To begin cutting or grinding, approach the material at an angle between

15 and 30 degrees to the wheel. Maintain that angle until you are finished

cutting/grinding. Do not force the wheel or apply too much pressure. If the

wheel slows down as you work with your material, you are applying too

much pressure.

Once you have turned the Grinder off, continue to hold onto the tool with

both hands until the motor stops completely before you set it down.

Caution: Always disconnect the Air Grinder from its compressed air

supply source before performing any cleaning, servicing, or maintenance.

Before use, add a few drops of light tool oil into the air inlet (26). See assem-

bly diagram on page 8. If the tool stops turning, the Rotor Blades (21) may be

gummed up or damaged. You can remove and clean them or replace them if

needed. See page 8. Call 1-800-444-3353 to order replacement parts.

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM

IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER

NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO

THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PROD-

UCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.

IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT

ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTI-

FIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES

ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL

PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER

INSTALLATION OF REPLACEMENT PARTS THERETO.

SKU 95504