Panasonic NV-MX1B Operating Instructions Manual page 5

Charge Lamp
Power Lamp
AC Adaptor
Title
3) Supplying Power with the Battery
Before use, fully charge the Battery.
When charging,
do not connect
the DC Input
Lead to the
AC Adaptor.
When the [CHARGE] Lamp Flashes Continuously
If the temperature of the Battery is extremely low or
extremely high, the [CHARGE] Lamp on the AC
Adaptor flashes continuously. It also flashes
continuously when some malfunction has occurred in
the Battery or the AC Adaptor. For details, read "Notes
about the AC Adaptor". (p. 115)
≥Charge the Battery at a room temperature between
10oC and 30oC.
≥If the DC Input Lead is connected to the AC Adaptor,
disconnect it as charging is not possible otherwise.
≥If the [CHARGE] Lamp does not light even though the
Battery is attached, remove the Battery and then re-
attach it.
≥During recording and charging, the Battery becomes
warm. However, this is normal.
≥If the temperature of the Battery is extremely high or
extremely low, the [CHARGE] Lamp may keep on
flashing and charging is not possible. After the
Battery has cooled down or warmed up sufficiently,
charging starts automatically.
8
Procedure
1 2
Have the front edge of Connect the AC Mains
the battery lined up with Lead to the AC Adaptor
the mark on the side and an AC mains socket.
of the AC Adaptor, and The [POWER] Lamp and
then slide it horizontally the [CHARGE] Lamp light
until it locks with a and charging starts.
click. ≥The AC Mains Lead
does not fit entirely into
the AC Adaptor socket,
however this has no
effect on operation.
5
Insert the Battery into the Battery Holder on the
Movie Camera and slide it downward until it locks
with a click.
NV-MX1
VSB0418
A
1 h.
CGR-D120
B
1 h 25 min. (1 h 5 min.)
C
45 min. (35 min.)
A
CGP-D210 1 h 50 min.
B
2 h 20 min. (1 h 55 min.)
C
1 h 10 min. (1 h.)
A
CGR-D220 2 h.
B
2 h 55 min. (2 h 20 min.)
C
1 h 30 min. (1 h 10 min.)
A
CGP-D320
3 h 15 min.
B
5 h 5 min. (4 h 5 min.)
C
2 h 35 min. (2 h 5 min.)
CGR-D815 A
5 h 20 min.
B
9 h 25 min. (7 h 40 min.)
C
4 h 45 min. (3 h 50 min.)
3 4
Remove the Battery by Tilt the Viewfinder
sliding it in the upward.
opposite direction of
Step 1 .
≥Also disconnect the AC
Mains Lead.
Charge Lamp [CHARGE]
Lit: During charging.
Off: When the Battery is fully charged.
Charge Lamp
NV-MX5 NV-MX7
1 h. 1 h.
1 h 20 min. (1 h 5 min.) 1 h 20 min. (1 h 5 min.)
40 min. (35 min.) 40 min. (35 min.)
1 h 50 min. 1 h 50 min.
2 h 20 min. (1 h 50 min.) 2 h 20 min. (1 h 50 min.)
1 h 10 min. (55 min.) 1 h 10 min. (55 min.)
2 h. 2 h.
2 h 50 min. (2 h 15 min.) 2 h 50 min. (2 h 15 min.)
1 h 25 min. (1 h 10 min.) 1 h 25 min. (1 h 10 min.)
3 h 15 min. 3 h 15 min.
4 h 50 min. (3 h 55 min.) 4 h 50 min. (3 h 55 min.)
2 h 25 min. (2 h.) 2 h 25 min. (2 h.)
5 h 20 min. 5 h 20 min.
9 h 10 min. (7 h 40 min.) 9 h 10 min. (7 h 40 min.)
4 h 35 min. (3 h 50 min.) 4 h 35 min. (3 h 50 min.)
Remarks, etc.
Charging Time and Maximum Time for
Continuous Recording
The times shown in the above chart are
approximations. The figures in parentheses show the
recording time when using the LCD Monitor.
The times listed above for your information indicate the
duration of recording performed at an ambient
temperature of 20°C and 60% relative humidity. The
charging time may be longer when you charge the
Battery at higher or lower temperature.
A
Charging Time
B
Maximum Continuous Recording Time
C
Intermittent Recording Time
(The Intermittent Recording Time indicates the total
recording time possible when you start and stop
recording repeatedly.)
≥The Battery Model VSB0418 is supplied.
≥During use and charging, the Battery becomes warm.
The Movie Camera, too, becomes warm during use.
≥When you repeatedly stop and restart recording, the
recording time per Battery is shorter than listed above.
≥If you do not use the Battery for a long time, please
read "Precautions for Storage". (p. 116)
≥The Battery models CGP-D110 and CGP-D105
cannot be charged with this AC Adaptor.
Removing the Battery from the Movie Camera
While pressing the [BATT. EJECT] Button, slide the
Battery upward to remove it.
≥Be careful not to drop the Battery by accident.
≥Before removing the Battery, set the [OFF/ON/MODE]
Switch to [OFF].
BATT.
EJECT
PUSH
Battery Eject Button
9