Functional Description; Specifications; Air Supply - Central Pneumatic 93088 Set Up And Operating Instructions Manual

FUNCTIONAL DESCRIPTION

Specifications

Maximum Air Pressure
Air Inlet
Maximum Speed*
Average Air Consumption 4.5 SCFM @ 90 PSI
Collet
* Maximum speed at stated maximum air pressure. Ex-
cess air pressure is hazardous and may cause the tool
to exceed stated maximum speed.
Air Angle Die Grinder Controls
INITIAL TOOL SET UP
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
SKU 93088
90 PSI
1/4" -18 NPT Female
20,000 RPM
1/4"
Air Inlet
(1)
Trigger Lever (4)
Safety Lock (41)
For technical questions, please call 1-800-444-3353.
Unpacking
When unpacking, make sure that
the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.

Air Supply

Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
1. Incorporate an in-line oiler, shut-off
valve, regulator with pressure gauge,
and filter for best service, as shown
in the diagram above. An in-line
shutoff valve is an important
TO PREVENT
EXPLOSION:
Page 7