Cub Cadet 1200 Operator's Manual page 34

LUBRICATION
ENGINE OIL -Continued
Keep your supply of lubricating oil absolutely
clean and free from dust. Always use clean
containers. Keep the lubricator clean and wipe dirtfrom
the lubrication fittings before applying thelubricator.
TRANSMISSION OIL FILTER
(International Cub Cadet 1250, 1450, and 1650
Tractors)
Remove the throw-away can-type filter and replacewith
a new filter after the first 10 hours and after
50 hours of operation, and every 100 hou rs of
operation thereafter.
1. Oil filler cap and oil level gauge -
Cub Cadet 800 Tractor
NOTE:
Clean the outside area before removing thefilter
to keep dirt from getting into the trans-
mission case. I f a mower is mounted on the tractor,the
mower must be lowered to facilitate removal of
the
filter.
To
remove the filter, turn the filter counter-clockwise
using an automotive type filter wrenchor
an open end wrench.
Before installing the new filter, apply a coating of
oil on the filter gasket. Thread the filter on by
hand until tight enough to seat the gasket. Loosen
the filter. Then turn it until the gasket contacts the
base. Tighten the filter an additional one half turn.
Check for leaks and check oil level of transmission
case.
1.
Oil filler cap and oil level gauge -All
models except the Cub Cadet 800 Tractor
NOTE: Right hand side panel removed to show
location.
32