Listening To Fm Radio - Panasonic SC-HC57DB Operating Instructions Manual

≥ If broadcasting stations are memorised, proceed to
"To re-scan DAB/DAB+ stations" to memorise stations on
other frequency blocks. (
≥ If "SCAN FAILED" is still displayed, repeat steps 1 to 4 until a
station is memorised. If the situation does not improve, try
using an outdoor DAB antenna or consult your dealer.
∫ Checking the DAB/DAB+ signal reception
quality
1
While listening to the DAB broadcast:
Press [PLAY MENU] repeatedly to select "SIGNAL
QUALITY" and then press [OK].
≥ The current frequency block is displayed and
then the reception quality is indicated.
2
If the signal reception quality is poor, move the
antenna to a position where the reception
quality improves.
3
To continue checking the quality of other
frequency blocks
Press [3, 4] again and select the desired
frequency.
4
Press
[OK] to exit.
If the antenna has been adjusted, perform auto scanning and
update the station memory. (
Changing the Auto scan
frequency range
Only the frequencies currently used in the UK as of
February 2012 on BAND III are Auto scanned ("United
Kingdom", factory setting).
Select "ALL BAND III" when you want to store stations
on other frequencies to memory.
1
Press [PLAY MENU] repeatedly to select "SCAN
MODE".
2
Press [3, 4] to select "ALL BAND III" or "UNITED
KINGDOM" and then press [OK].
≥ The "DAB AUTO SCAN" begins automatically.
≥ The DAB preset channels are erased when the
"SCANMODE" is changed.
≥ If the play timer has been set and DAB/DAB+ is the music
source, the timer switches off. (
15)
15)
19)

Listening to FM radio

You can preset up to 30 channels.
Preparation
Make sure that the DAB antenna is connected. (
A station previously stored is overwritten when another station
is stored in the same channel preset.
Presetting stations
automatically
1
Press [RADIO] to select "FM".
2
Press [PLAY MENU] repeatedly to select
"A.PRESET" and then press [OK].
3
Press [3, 4] to select "LOWEST" or "CURRENT"
and then press [OK].
LOWEST:
To begin auto preset with the lowest frequency
(FM 87.50).
CURRENT:
To begin auto preset with the current frequency.*
* To change the frequency, refer to "Manual tuning and
presetting".
The tuner starts to preset all the stations it can receive
into the channels in ascending order.
Listening to a preset channel
Preparation
1
Press [RADIO] to select "FM".
2
Press [PLAY MENU] repeatedly to select
"TUNEMODE" and then press [OK].
3
Press [3, 4] to select "PRESET" and then press
[OK].
1
Press [RADIO] to select "FM".
2
Press [:/6] or [5/9] to select the
channel.
∫ Manual tuning and presetting
Select a radio broadcast.
1
Press [RADIO] to select "FM".
2
Press [PLAY MENU] repeatedly to select
"TUNEMODE" and then press [OK].
3
Press [3, 4] to select "MANUAL" and then press
[OK].
4
Press [:/6] or [5/9] to tune to the
required station.
≥ To start automatic tuning, press and hold [:/6],
[5/9] until the frequency starts scrolling. Tuning
stops when a station is found.
10)
(Continues to next page)
RQT9709
17