Specifications - Siemens Gigaset C340 Operating Instructions Manual

Gigaset C340 / CHIN eng / A31008-M1621-Y101-1-7619 / appendix.fm / 14.9.05
The caller's number is not displayed despite
CLIP.
Number identification is not enabled.
¥
The caller should ask his network service
provider to activate Calling Line Identifica-
tion (CLI).
You hear an error tone when keying an
input
(a descending sequence of tones).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the operat-
ing instructions if necessary.
You cannot hear the select services.
Your phone system is set for pulse dialling.
¥
Set your phone system to tone dialling.

Specifications

Recommended batteries
Nickel-metal-hydride (NiMH):
u
Sanyo Twicell 700
u
Sanyo Twicell 650
u
Sanyo NiMH 800
u
GP 700mAh
u
GP 850mAh
u
Yuasa Technology AAA Phone 700
u
Yuasa Technology AAA 800
u
VARTA Phone Power AAA 700 mAh
The handset is supplied with two recom-
mended batteries.
Handset operating times/
charging times
Capacity
Standby time
Calling time
Charging time
The operating and charging times apply
only when using the recommended bat-
teries.
700 mAh
approx. 170 hours (7 days)
approx. 15 hours
approx. 7 hours
Power consumption of the base
In readiness mode: approx. 2W
During a call: approx. 2W
General specifications
WDCT standard is supported
No. of channels 80 duplex channels
Wireless freq- 2400-2483.5 MHz
uency range
Duplex method Time multiplex, 10 ms
frame length
Channel spacing 864 kHz
Bit rate 576 kbit/s
Modulation GFSK
Transmission Max 25 mW, average
power power per channel
Range up to 300 m outdoors,
up to 50 m indoors
Power supply/Base 220 V ~/50 Hz
Environmental +5 °C to +45 °C;
conditions in oper-
20 % to 75 % humidity
ation
Dialling mode DTMF (tone dialling)/DP
(dial pulsing)
Recall 100 ms
Dimensions, base 109 x 115 x 90 mm
station
(L x W x H)
Dimensions, 158 x 59 x 32 mm
handset
(L × W × H)
Weight of base 124 g
Weight of handset 128 g
with battery
Default settings
Your Gigaset M56 is supplied with the
default settings shown in the tables.
You can restore these default settings
(page 23, page 24).
Appendix
27