Table of Contents
Advertisement
Comments:
Your fax will not accept the signal to begin reception (5
loaded in its feeder.
If you have set Option Setting 16 to NO and hear a fax tone when you answer
the extension phone, you must press 5,
phone, or walk over to the fax, pick up the handset, and press the START key
if you are on a pulse dial only phone.
The code used to activate fax reception from a tone dial extension phone
**
(5
) can be changed if desired. See Option Setting 6 (Tel/Fax Remote
Number) in Chapter 8, Option Settings.
Reception Ratio
The fax has been set at the factory to automatically reduce the size of
received documents to fit the size of the printing paper. This ensures
that data on the edges of the document are not cut off. If desired, you
can turn this function off and have received documents printed at full
size.
Note: If a document is too long to fit on the printing paper, the remainder
will be printed on a second page. In this case, the cut-off point may occur
in the middle of a line.
Note: Automatic reduction may not be possible if the received document is
too large, contains too many fine graphics or images, or is sent at high
resolution. In this case, the remainder of the document will be printed on a
second page.
1
Press these keys:
The display will show:
*
*
, and
FUNCTION
6
RECEPTION RATIO
Receiving Documents
**
) if a document is
if you are on a tone dial
57
Advertisement
Table of Contents
