Table of Contents
Advertisement
6.
WARNING! The Auger (33a)
should do not turn at idle. If it
is turning at idle, turn the
Idle Screw of the Carburetor
(shown right) counterclock-
wise to reduce the idle RPM
and stop the Auger, or imme-
diately discontinue using the
Auger Drill and contact a quali-
fied service technician to make the
adjustment.
7.
Once the Engine is started, set the
Choke (76) to its open position.
8.
If the Engine
Primer (95) again. Set the Choke (76) to its closed position, and again attempt to
start the Engine. (See figure c.)
NOtE:
9.
If the Engine is new, or has been stored for a long period of time, pull the
Starter Handle (7) several times to ensure sufficient fuel is delivered into the fuel
line and combustion chamber of the Engine. (See figure c.)
10.
As soon as the Engine is running, check to make sure the Choke (76) is in its open
position. Squeeze the Speed Control (10b) briefly and let up. The Speed Control will
revert to its original position, causing the Engine to idle. (See figures c and D.)
11.
To stop the Auger Drill, release pressure on the Speed Control (10b). Then, press
down on the Kill Switch (5b). Keep your thumb near the Kill Switch in the event
the Auger Drill must be stopped immediately. (See figure D.)
SKU 95346
for technical questions, please call 1-800-444-3353
Idle Stop
Location
does not start, press the
SPEED cONtROL (10b)
fIGURE D
Screw
KILL SWItcH (5b)
REV 07e
PAGE 10
Hide quick links:
Advertisement
Table of Contents
