Belt Clip And Headset - Gigaset C460 User Manual

First Steps
Please note:
– Automatic registration is not possible when the
base station on which you wish to register the
handset is being used to make a call.
– A key press cancels automatic registration.
– If four handsets are already registered to the base
station there are two options:
– The handset with the internal number 4 is in
idle status: the handset you wish to register is
assigned the number 4. The handset that was
previously number 4 is de-registered.
– The handset with the internal number 4 is
being used: the handset you wish to register
cannot be registered.
– If automatic registration does not work the hand-
set will have to be registered manually (page 20).
¤
To charge the batteries, leave the handset in
the charging cradle on the base station.
Please note:
– The handset may only be placed in the base pro-
vided for it.
– If the handset has switched itself off because the
batteries are flat and is then placed in the cradle,
it will switch itself on automatically.
For questions and problems see page 26.
Initial charging and discharging of
batteries
Battery charging is indicated in the top right of
the display by a flashing battery icon
U
or . During handset operation, the battery
icon indicates the charge status of the batteries
(page 1).
The correct charge status can only be displayed
when the batteries are first fully charged and
discharged through use.
¤
To do this, leave the handset in the base
without interruption until the battery icon
stops flashing in the display (approx. 13h).
¤
Once the batteries are fully charged, remove
the handset from the base and do not put it
back again until the batteries are fully dis-
charged.
Please note:
After the first battery charge and discharge you may
replace your handset in its base after every call.
6
Please remember:
u
Always repeat the charging and discharging
procedure if you remove the batteries from
the handset and re-insert them.
u
The batteries may warm up as they are
charging. This is not dangerous.
u
After a time the charge capacity of the bat-
teries will decrease for technical reasons.
Please note:
You will find explanations for the symbols and typo-
graphical conventions used in this user guide in the
appendix, page 26.
Setting the date and time
§Menu§
~
~
Once the phone is registered and the time
set, the idle display looks as shown on
page 1.
Your phone is now ready for use.

Belt clip and headset

e V
,
By using a belt clip and headset (optional) you
can easily make your mobile phone a constant
companion both inside the building and in its
immediate vicinity.
Attaching the belt clip
There are notches for attaching the belt clip on
the side of the handset at approximately the
same height as the display.
¤
Press the belt clip onto the back of the hand-
set so that the protrusions on the belt clip
engage with the notches.
Connection socket for headset
You can connect the following types of headset
(with jack connector): HAMA Plantronics M40,
MX100 and MX150.
¢ ¢
Settings Date/Time
Enter the day, month and year
with 6 digits and press
q
to move between the fields.
Enter hours and minutes with 4
digits (e.g. 0 7 1 5 for 07.15 hrs)
and press . Use
§OK§
between the fields.
. Use
§OK§
q
to move