Battery Information - Gigaset 100 Operating Manual

Gigaset 100, GB/IRL, A31008-G100-B100-2-7619
Putting the telephone into service
Step 4: Charging the battery
The battery supplied is not charged.
Step 5: Setting short flash time (100ms) for the
signalling key
A short flash time (100ms) is required to operate the recall
key. Press the following keys to set the flash time:

Battery information

• Once the first charging operation is completed, you can
replace the handset in the base station after any call.
• The batteries warm up during charging - this is normal
and not a cause for concern.
Handset operating times/charging time
Capacity
300 (mAh)
Power consumption in standby mode
No charging
While charging
Approved battery
Nickel-cadmium (NiCd)
Type 1a (300 mAh)V30145-K1310-X147 NiCd
Batteries are available from your stockist or via the Internet,
from Siemens Service Shop at:
http://www.siemens.siemens.ie/shop; alternatively see also
last page.
To charge the battery, place the handset in
the base station. For the first charging we
recommend a continuous charging time for
at least 16 hours. You can then make calls.
Standby
time
up to 100 h
approx. 1.7 watts
approx. 2.1 watts
7
Giga100.fm
Charging
Talktime
up to 10 h approx. 16 h
02.04.01
time