American Standard Ceramix 2021.6XX Installation Instructions

KITCHEN FAUCETS
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
TOOLS REQUIRED
Channel Locks
1
Turn off water at
CAUTION
main supply.
Install ESCUTCHEON (optional)
Peel off paper backing from WASHER (1, 1a) and stick WASHER
(1, 1a) into circular groove of the SUPPORT PLATE (2, 2a).
Place SUPPORT PLATE (2, 2a) in
center of ESCUTCHEON (3, 3a)
with WASHER (1) visible.
Turn ESCUTCHEON (3, 3a) over
with notch of SUPPORT
PLATE (2, 2a) towards rear of
sink, align STUDS (4) with
outer holes of sink and
place ESCUTCHEON (3, 3a) onto
deck. Hole of SUPPORT
PLATE (2, 2a) must align with
hole of sink.
2
FAUCET INSTALLATION (ESCUTCHEON OPTIONAL)
Insert supply TUBES (1) and threaded MOUNTING STUD (2)
through center hole of ESCUTCHEON (3) and sink deck, or selected
sink hole if ESCUTCHEON (3) is not used.
Make sure black RUBBER GASKET (4) is properly centered on base.
Orient faucet so that threaded STUD (2) is centrally located towards
rear of sink, then assemble RETAINER PLATE with GASKET (5), or
MOUNTING KIT (5a) and thread LOCKNUT (6, 6a) onto MOUNTING
STUD (2) from underside of sink.
Hand tighten LOCKNUT (6, 6a) and check that rotation of HANDLE (7)
from HOT to COLD is centered. Secure faucet by tightening LOCKNUT
(6, 6a) firmly. Spread TUBES (1) for better access to LOCKNUT (6, 6a).
If using ESCUTCHEON (3), thread ESCUTCHEON WING NUTS (8) onto
studs from underside of sink and hand-tighten.
T M
Adjustable Wrench
2
1
4
3
Installation
Instructions
2021.6XX
Plumbers' Putty or Caulking
FOR MODEL 2021.631 ONLY:
Install ESCUTCHEON (3a) (as described on the left).
Insert SPRAY HOLDER (5) through side hole of installed
ESCUTCHEON (3a), thread WING NUT (6) to shank of SPRAY
HOLDER (5) from underside of sink. Center SPRAY HOLDER (5)
on ESCUTCHEON (3a) and secure by tightening WINGNUT (6).
INSTALL
6
7
2
3
8
6
LOCKNUT
(FAUCETS
LESS SPRAY)
6a
LOCKNUT
Certified to comply with ASME A112.18.1M
M 6 6 2 4 0 R E V. 1 . 1
Phillips Screwdriver
5
INSTALL
3a
2a
4
3a
LESS ESCUTCHEON
4
1
5
5
6
5a
MOUNTING KIT
FOR FTG. WITH
HAND SPRAY
4
1
6a