Checking The Signalling Method Of Your Telephone Line; Setting The Signalling Method; Operation In Conjunction With A Pbx - Gigaset 2015 Operating Instructions Manual

4.8.99
Important basic settings

Checking the signalling method of your telephone line

Setting the signalling method

033
O
038
O

Operation in conjunction with a PBX

12
KAP04.FM4
You can check which method of signalling has been set
on your telephone.
c
Dial a number. If your Gigaset 1015 is linked to a PBX
(telecommunications system), you may have to press a
further key or keys to obtain an outside line.
You hear dial tone.
Press any digit, e.g. 2. If the same dial tone is audible as
o
previously, you will have to change the signalling method.
#1
B
Start the procedure.
Enter the 4-digit system code; default 0000
o
( page 14).
B
Set dial pulsing (DP).
or
B
Set dual-tone multifrequency signalling (DTMF)
(PBX recall button flash, short/80 ms).
If you operate your Gigaset 2015 in connection with a
PBX (telecommunications system), you can set the fol-
lowing for switching to the public telephone network:
the trunk code
the length of the pause following the trunk code
If the PBX is a satellite to a main PBX, you can set the
following:
the trunk code
the main trunk code
the length of the pause following the trunk code/main
trunk code
Gigaset 2015, GBR: A30852-X-1105-B301-1-7619
For details of the trunk code/main trunk code
and the length of pause please refer to the PBX
documentation.