Camera, Laminator, And Die Cutter Setup; Set The Processing Timer - Polaroid ID100 User Manual

Camera, Laminator, and
Die Cutter Setup
System must be grounded using a power cord with a three-
pronged grounded plug (applies only in countries with grounded
electrical supplies), which must be plugged into an appropriate
outlet. Do not under any circumstances remove ground prong
from plug. If extension cord is needed, use cord with grounded
plug and suitable power rating.
1
Pull the knob and hold it out.
2
Grasp the camera and swing it
into the upright position. The
camera head locks into position.
3
Plug in the camera power cord,
and then connect it to the elec-
trical outlet.
4
Place the laminator in a conven-
ient location, and then place the
die cutter on top.
5
Plug the laminator power
cord into the camera base.
6
Turn the key to turn on the
camera system power; move
the laminator switch to the
heat position.
The laminator must
Note:
warm up for 5 minutes before
use.

Set the Processing Timer

Before setting the timer, remove the insulation strip (a) protect-
ing the timer's battery during shipment.
1
Press the MIN button to set
minutes (larger numbers).
The next higher number
appears with each press. It
displays "01" after the first
press, "02" after the second.
2
Press the SEC button, to set seconds (smaller numbers). The
next higher number appears with each press. It displays "01"
for one second or "10" for ten seconds.
3
Press START to start the timer.
4
Press the MIN and SEC buttons simultaneously, to clear the
numbers.
RUN
HEA T OFF
Replacement battery: The timer uses one #LR44 or equivalent bat-
tery. They can be purchased wherever watch, calculator, or hearing
aid batteries are sold.
2
F RU N
HE AT OF
a