Martin MAC 300 User Manual page 10

P e r s o n a l i t y s e t t i n g s
The MAC 300's personality settings are shown in Table 3; they are described as well in the following section. To select
a personality setting:
Press [Menu] as required to reach the main menu. Navigate to
1.
2. Navigate to the desired setting and press [Enter].
3. Select the desired option with the arrow keys and press [Enter].
Personality
Pan/tilt swap
Pan inverse
Tilt inverse
Pan/tilt speed
DMX lamp off
DMX reset
Automatic lamp on
Display on/off
Display intensity
Dimmer mode
Shortcuts
Effects feedback
Tracking algorithm
Tracking samples
C u s t o m p e r s o n a l i t y c o n f i g u r a t i o n s
Three sets of custom personality configurations can be stored for later recall. To create and use a custom configuration:
1. Set the personalities as desired.
2. Navigate to
3. Select
4. Select
5. To load the factory default personality settings, navigate to
[Enter].
10
Path Options
ON
PATI /SW AP
OFF
ON
PATI/PINV
OFF
ON
PATI/TINV
OFF
FAS T
PTSP
SLO W
ON
dLOF
OFF
ON
dRES
OFF
ON
ALON
OFF
ON
dISP
OFF
dINT 10 100
-
NOR M
dMOd
TUN G
ON
SCUT
OFF
ON
EFFb
OFF
MOd 1
TRAC/MOdE
MOd 2
TRAC/CAL 1-1 0
Table 3: Personality settings
/ and press [Enter].
PE RS d FSE
CUS 1 , CU S2 , or CUS 3
SAV E to create a custom configuration or
Effect (Default setting shaded, * indicates DMX override)
Map DMX pan control to tilt channel and vice versa.
Normal pan and tilt control.
Reverse DMX pan control (right
Normal pan control (left
Reverse DMX tilt control (down
Normal tilt control (up
Optimize movement for speed.*
Optimize movement for smoothness.*
Enable DMX lamp off command.
Disable DMX lamp off command.*
Enable DMX reset command.
Disable DMX reset command.*
Lamp strikes automatically within 90 seconds of power on.
Lamp remains off until "lamp on" command is sent.
Display stays on.
Display goes out 2 minutes after last key press.
Adjust display intensity.
Normal dimming.
Simulated tungsten dimming.
Color and CMY wheels turn the shortest direction.*
Wheels turn same direction.*
Enable feedback on color and CMY wheels.
Disable feedback on color and CMY wheels.
Absolute delta value algorithm (for most controllers)
Real delta value algorithm
Tracking samples. Increase if pan/tilt is not smooth.
and press [Enter].
LO Ad
Fixture Settings
and press [Enter].
PE RS
Æ
left).
Æ Æ Æ Æ
right).
Æ
up).
Æ Æ Æ Æ
down).
to recall. Press [Enter].
PER S / dF SE / FA CT and press