Table of Contents
Advertisement
2. Connecting the AC Adaptor
3
1
3. Switch TV ON
4. Auto set up
Land
Start ATP
Suchlauf
Abbruch
2
Power-Indicator
The RED LED when
indicates that not only
the TV set is in stand-
by mode but also the
external AC adaptor is
still on.
AUTO SETUP IN PROGRESS
SEARCHING:PLEASE WAIT
02
SETUP : Return to tuning menu
TV/AV
: To exit
1
Connect the mains lead to the AC Adaptor.
2
Connect the AC Adaptor DC plug to the DC IN socket.
3
Plug into household mains socket.
• Be sure to use the power cord and AC adaptor
included in the accessories.
• Do not use the AC adaptor for other than the
specified equipment.
• Unplug the AC adaptor if it is not used for long
time.
• Do not place any objects on the AC adaptor.
• Do not use the AC adaptor outdoors.
• Do not attempt to repair the AC adaptor if it is
broken or malfunctioning. Refer the servicing to
the service representative.
• Do not try to open the AC adaptor.
• Do not use water or wet cloth for cleaning the
AC adaptor.
Press the
the set on.
There are two ways to switch the TV set to
stand-by mode.
(A) Press the
check RED LED is lit.
(B) Press the
control.
The TV set can be switched on by the remote
controller if it was switched to stand-by using
method (A) or method (B).
When programme number up ( )/down ( )
buttons on the side panel of the main part are
pressed in stand-by mode, TV turns on.
If the TV has not been programmed for you then
Auto setup will begin, your stations will be
located, sorted into order and stored ready for
use (refer to P18).
99:21 41
Quick start Guide
switch on the LCD TV to turn
IMPORTANT NOTES
switch on the LCD TV and
OR
Stand-by button on the remote
7
Advertisement
Table of Contents
