Panasonic KX-TG7160E Operating Instructions Manual page 38

TG7160-7180E(e).book Page 38 Thursday, July 27, 2006 12:45 PM
Useful Information
Problem
Pressing {R} does not
display/dial the last number dialled.
The handset beeps intermittently
and/or 7 flashes.
I fully charged the batteries, but
7 still flashes.
I fully charged the batteries, but the
operating time seems to be short.
Caller information is not displayed. L You need to subscribe to Caller ID service. Consult
The handset does not announce
the displayed phone number.
While viewing caller information,
the display returns to standby
mode.
I cannot register a handset to the
base unit.
38 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Cause & solution
L The redialled number was more than 24 digits long.
Redial the number manually.
L Fully charge the batteries (page 12).
L Clean the charge contacts and charge again (page
12).
L It is time to replace the batteries (page 11).
L Wipe the battery ends (S, T) and the unit contacts
with a dry cloth.
your service provider/telephone company for
details.
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.
L The handset ringer volume is turned off. Adjust it
(page 19).
L The voice announce feature is turned off. Turn it on
(page 14).
L While you are on an outside call, the handset does
not announce phonebook information when
searching the phonebook.
L Do not pause for over 1 minute while searching.
L The maximum number of handsets (6) are already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 31).
L You entered the wrong PIN number. If you forget
your PIN, consult your nearest Panasonic service
centre.
L Place the handset and the base unit away from
other electrical appliances.