Table of Contents
Advertisement
TG7200-7220FX(e-e).book Page 40 Friday, June 29, 2007 10:24 AM
Useful Information
Telephone
Problem
Cause & solution
w is flashing.
L The handset is not registered to the base unit.
L The handset is too far from the base unit. Move
L The base unit AC adaptor is not connected. Check
L You are using the handset or base unit in an area
The handset display is
L The handset is not turned on. Turn the power on
blank.
The handset will not
L Make sure that the batteries are installed correctly
turn on.
L Fully charge the batteries (page 10).
L Clean the charge contacts and charge again
I have changed the
L Change the display language (page 11).
display language to a
language I cannot
read.
I cannot make or
L The base unit AC adaptor or telephone line cord is
receive calls.
L If you are using a splitter to connect the unit,
L Disconnect the base unit from the telephone line
L The dialling mode setting is incorrect. Set to
L The key lock feature is turned on. Turn it off
The unit does not ring. L The ringer volume is turned off. Adjust the ringer
40
Register it (page 33).
closer.
the connections.
with high electrical interference. Place the handset
and base unit away from interference sources,
such as antennas and mobile phones.
(page 11).
(page 9).
(page 10).
not connected. Check the connections.
remove the splitter and connect the unit to the wall
socket directly. If the unit operates properly, check
the splitter.
and connect the line to a known working telephone.
If the working telephone operates properly, contact
our service personnel to have the unit repaired. If
the working telephone does not operate properly,
contact your service provider/telephone company.
"Tone" or "Pulse" as needed (page 12).
(page 14).
volume (page 17, 19).
Hide quick links:
Advertisement
Table of Contents
