Connecting The Power Terminal; Connecting The Speaker Output Terminals - Pioneer PRS-D400 Owner's Manual

MAN-PRS-D400-GB.fm Page 6 Tuesday, February 21, 2006 3:43 PM
Connecting the Unit

Connecting the Power Terminal

• Always use the special red battery and ground wire [RD-223], which is sold
separately. Connect the battery wire directly to the car battery positive terminal (+)
and the ground wire to the car body.
1. Pass the battery wire from the engine
compartment to the interior of the
vehicle.
• After making all other connections to
the amplifier, connect the battery
wire terminal of the amplifier to the
positive (+) terminal of the battery.
2. Twist the battery wire, ground wire
and system remote control wire.
3. Attach lugs to wire ends. Lugs not
supplied.
• Use pliers, etc., to crimp lugs to
wires.
4. Connect the wires to the terminal.
• Fix the wires securely with the
terminal screws.
Engine
Fuse (30 A)
Interior of the
compart-
vehicle
ment
Fuse (30 A)
Drill a 14 mm
hole into the
Positive terminal
vehicle body.
Insert the O-ring rubber
grommet into the vehicle
body.
Twist
Lug
Ground wire
Lug
Battery wire
GND terminal
System remote control
Power
terminal
terminal
System remote
control wire
Ground wire
Battery wire
! WARNING
Failure to securely fasten the battery wire to the terminal using the terminal screws
could cause the terminal area to overheat and could result in damage and injury
including minor burns.

Connecting the Speaker Output Terminals

1. Expose the end of the speaker wires
using nippers or a cutter by about
10 mm and twist.
2. Attach lugs to speaker wire ends.
Lugs not supplied.
• Use pliers, etc., to crimp lugs to
wires.
3. Connect the speaker wires to the
speaker output terminals.
• Fix the speaker wires securely with
the terminal screws.
Speaker
terminal
6
Twist
10 mm
Lug
Speaker wire
Terminal screw
output
Speaker
wire