Video In / Out Settings - Pioneer DVR-310 Operating Instructions Manual

The Initial Setup menu
5 Press ENTER to swap the presets.
6 If you want to swap more presets, press
(cursor left), then repeats steps 3 to 5.
7 Press HOME MENU to finish and exit.
VCR Plus+ CH Setting
• Default setting: n/a
Guide channels are used by the VCR Plus+ system so
that the channel number specified in the PlusCode
programming numbers can be guaranteed to
correspond to the correct station.
1 Select 'VCR Plus+ CH Setting', then 'Next Screen'.
Initial Setup
Basic
Auto Channel Setting
Tuner
Manual CH Setting
Video In/Out
Channel Swapping
Audio In
VCR Plus+ CH Setting
Audio Out
Language
Recording
Playback
2 Assign channel numbers to the guide channels as
necessary.
Look in your TV guide to see which channel numbers
should be assigned to which guide channels.
Initial Setup
VCR Plus+ CH Setting
Basic Auto Channel Setting
Guide Preset
Tuner Manual CH Setting
Video In/Out Channel Swapping
Audio In VCR Plus+ CH Setting VCR Plus+ CH Setting
Audio Out
Language
Recording
Playback
• Use the (cursor up/down) buttons to change
the guide channel for setting.
• Use the (cursor left/right) buttons to change
the channel number.
• Use the PREV / NEXT button to display the previous/
next 10 guide channels.
3 To return to the Initial Setup menu, press ENTER.
Next Screen
1/26
Guide Preset
1 Pr 4 6
2 7
3 8
4 9
5 10

Video In / Out settings

Input Colour System
• Default setting: 3.58 NTSC or Auto (depending on
region)
Initial Setup
Basic Input Colour System
Tuner Component Video
Video In/Out NTSC on PAL TV
Audio In
Audio Out
Language
Recording
Playback
On the default setting, the recorder automatically detects
whether the video signal from the built-in tuner or from
one of the external inputs is PAL, SECAM, 3.58 NTSC or
PAL–60, PAL–M or PAL–N. You may, however,
occasionally need to set it manually if the picture is not
displayed properly.
1 Select 'Input Colour System', then 'Next Screen'.
2 Use the CHANNEL +/– buttons, the front panel
SMART JOG dial or the INPUT SELECT button to
switch between the built-in tuner and the external
inputs.
3 Use the (cursor left/right) buttons to
change the input colour system for the current input
or built-in tuner.
• The available settings depend on the Input Line
System setting (see Input Line System on page 74).
The table below shows the different options available.
(for South American model only)
Input Line System Built-in tuner
625 System Auto
SECAM
PAL-N
525 System Auto
3.58 NTSC
PAL-M
Next Screen
Pr 5
Auto
External input
Auto
SECAM
PAL-N
Auto
3.58 NTSC
PAL–M
12
77
En