Specifications - Panasonic TX-21AT1F Operating Instructions Manual

Colour television
Table of Contents

Advertisement

USER INFORMATION
H Service
Before requesting service look through the Troubleshooting . To
obtain service get in touch with your dealer and tell them your
television model type and serial number (to be found on the rear
panel).
H TV games/Home computers
Frequent use of the games console or computer may cause
"shadows" on the screen. This can be avoided if you meet the
following requirements:
` Reduce brightness and contrast to minimum;
` Do not use your television continuously with the game
console and computer
` Remember that this type of screen damage is not an
operation defect and is not covered by the Panasonic
warranty.

SPECIFICATIONS

Model
Power source
Power consumption
Power used in Standby mode
Screen
51 cm diagonal
Sound
(music)
Dimensions
Weight
TV systems/zones
TV systems/zones
Number of programme positions
Aerial input --- rear
Headphones output --- front
AV connector --- rear
AV connector --- front
The specifications may be subject to change without notice. Weight and dimensions are approximate.
18
5W RMS (10W MPO), impedance 8Ω. − mono
H
W
D
PAL B/G, PAL-60, SECAM B/G
VHF E2 - E12
VHF A - H (ITALY)
CATV (S01 - S05)
CATV S11 S20 (U1 U10)
CATV S11 - S20 (U1 - U10)
PAL D/K, SECAM D/K
VHF R1 - R2
VHF R6 - R12
M.NTSC playback (via AV input) from VCR NTSC 4.43 MHz
NTSC playback (via AV input) from VCR NTSC
AV1--- 21---pin connector --- AV input/output, RGB input, Q---Link
Front AV --- RCA sound signal input, 1 x RCA video signal input
H Last settings saved
Some functions allow the last settings to save , i.e. the following
settings will be activated when you turn on the television again:
Programme positions
Q-Link
Volume correction (+AV)
Volume
Brightness
Standby mode
Country
H Automatic switch---off (Sleep Function)
If the television remains switched on when the station ends
transmission, the television will automatically be put in standby
mode after 30 minutes. This function does not operate in the AV
mode.
TX-21AT1F
220 - 240 V, 50Hz AC power source
55W
0.9W
51 cm
476 mm
524 mm
473 mm
22 kg
VHF H1 - H2 (ITALY)
UHF E21 - E69
CATV S1 - S10 (M1 - M10)
CATV S21 S41 (Hyperband)
CATV S21 - S41 (Hyperband)
VHF R3 - R5
UHF E21 - E69
99 + VCR
UHF / VHF
3.5 mm, impedance 8Ω
Tint
Last viewed programme
Contrast
Sharpness
Colour
Status
OSD language

Advertisement

Table of Contents
loading

Table of Contents