Channel Installation; Change Smart Clone Settings - Philips HD TV User Manual

Channel installation

Install DVB-T/T2, DVB-C or analog channels
broadcast over cable.
In professional mode, select [Installation],
then press OK. The channel installation list
appears, allowing you to choose the type of
channels to install:

[DVB-T/T2 ]: Install DVB-T/T2
channels by selecting [On].

[DVB-C ]: Install DVB-C channels by
selecting [On].

[Analog]: Install analogue channels by
selecting [On].
Change Smart Clone
settings
Smart Clone allows you to easily clone TV
settings from one Philips TV to another. The
feature also allows you to download
software updates via RF or IP (Internet
Protocol).
Clone TV settings
Easily copy TV settings to a USB storage
device, then clone the settings onto another
Philips TV.
Copy TV settings to USB
1. Connect a formatted USB storage device
to a USB connector on the TV.
2. In professional setup menu, select [Smart
Clone] > [USB to TV], then press OK. All
TV settings are copied to the USB device.
Clone TV settings to another TV
1. Connect the USB device to to the Philips
TV to be cloned.
2. In professional setup menu, select [Smart
Clone] > [TV to USB], then press OK. All
TV settings are cloned to the TV.
EN 30
Download software via RF
The TV supports downloading of software
via RF (Radio Frequency).
1. In professional setup menu, select [Smart
Clone] > [RF download].
2. Use the Navigation buttons to select a
setting to change, then press OK:

[Enable]: Enable or disable RF
download.

[SW Type]: Specify the type of
software to download.

[Program Info]: Specify RF details such
as frequency, modulation and
connection type (cable or antenna).

[Start Download]: Start RF download.
Once the TV successfully downloads
the software, it automatically installs the
downloaded data onto the TV.
IP software upgrade
The TV supports software upgrades via IP
(Internet Protocol).
1. In professional setup menu, select [Smart
Clone] > [IP Upgrade].
2. Use the Navigation buttons to select a
setting to change, then press OK:

[Enable]: Enable or disable IP upgrade.

[SW Type]: Specify the type of
software to upgrade.

[Start upgrade]: Start the upgrade and
display the status page.