• Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications and battery cartridge may differ from country to country. • Weight, with battery cartridge, according to EPTA-Procedure 01/2003 END004-4 Model BTD133 Symbols Sound pressure level (L ) : 92 dB(A) The following show the symbols used for the equipment.
Keep children and bystanders away while Makita Corporation responsible operating a power tool. Distractions can cause manufacturer declare that the following Makita you to lose control. machine(s): Electrical safety Designation of Machine: Power tool plugs must match the outlet. Never Cordless Impact Driver modify the plug in any way.
Page 4
under the influence of drugs, alcohol or power tool’s operation. If damaged, have the medication. A moment of inattention while power tool repaired before use. Many accidents operating power tools may result in serious are caused by poorly maintained power tools. personal injury.
Wear ear protectors. Tips for maintaining maximum battery life Charge the battery cartridge before completely SAVE THESE INSTRUCTIONS. discharged. Always stop tool operation and charge the WARNING: battery cartridge when you notice less tool DO NOT let comfort or familiarity with product power.
Page 6
With the light button in the OFF status, even if the trigger Switch action is pulled, the lamp will not light on. 1. Switch trigger NOTE: To make sure the status of light, pull the trigger. • When the lamp lights up by pulling the switch trigger, the light switch is in the ON status.
Page 7
3. Medium 4. Soft 5. Hammering force button 011217 Hammering force grade Maximum blows Application Work displayed on panel BTD133 BTD145 Hard Tightening in underwork Tightening when force 3,400 3,200 material/ Tightening long and speed are desired. (min ) (min ) screws/ Tightening bolts.
Page 8
When the status is still unchanged, stop using and have the tool repaired by a Makita local service center. 011406 ASSEMBLY To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go.
To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out. Standard bolt (kgf cm) NOTE: (1224) If the bit is not inserted deep enough into the sleeve, • the sleeve will not return to its original position and (1020) the bit will not be secured.
60 seconds to restart the tool.) If the motor still remains locked, stop using and have the tool repaired by a Makita local service center. Switch trigger has been pulled Release the switch trigger.
Page 11
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Screw bits • Hook • Plastic carrying case •...
Page 12
Makita Corporation Anjo, Aichi, Japan www.makita.com 884965A228...