Cleaning And Replacing The Air Filter - Panasonic PT-AE200E Operating Instructions Manual

LAMP indicator
Indicator
Illuminated (red)
display
It is nearly time to An abnormality has been detected in the lamp
replace the lamp circuit.
Problem
unit.
B Does "REPLACE B The power may
LAMP" appear on
Possible
the screen after
cause
the projector is
turned on?
B This occurs when B Wait for a while
the operation time
for the lamp unit is
nearing 1800
hours. (when
LAMP POWER
has been set to
Remedy
"HIGH") Ask your
dealer or an
Authorised
Service Centre to
replace the lamp
unit.
NOTE:
B Be sure to turn off the MAIN POWER switch by following the procedure
given in "Turning off the power" on page 23 before carrying out any of the
procedures in the "Remedy" column.
B If the main power turns off after the TEMP indicator starts flashing, it
means that an abnormality has occurred. Please contact an Authorised
Service Centre so that the necessary repairs can be made.
52-E
NGLISH
Flashing (red)
B There may be an
have been turned abnormality in the
on straight away lamp circuit.
after it was turned
off.
B Turn off the MAIN
until the lamp unit POWER switch by
cools down before following the
turning the power procedure given
back on again. on page 23, and
then contact an
Authorised
Service Centre.

Cleaning and replacing the air filter

If the air filter becomes clogged with dust, the internal temperature of the
projector will rise, the TEMP indicator will flash and the projector power will
turn off. The air filter should be cleaned every 100 hours of use,
depending on the location where the projector is being used.
Cleaning procedure
# Turn off the MAIN POWER
switch and disconnect the
power cord plug from the wall
outlet.
Turn off the MAIN POWER switch
according to the procedure given
in "Turning off the power" on
page 23 before disconnecting the
plug from the wall outlet.
$ Gently turn the projector
upside down.
NOTE:
B Place the projector on top of a
soft cloth so that it will not
become scratched.
% Remove the air filter.
Put your fingernails under the air
filter and pull the air filter out of
the projector.
Air filter
& Clean the air filter.
Use a vacuum cleaner to clean
off any accumulated dust.
NOTE:
B Be careful not to let the air filter
get sucked into the vacuum
cleaner.
' Install the air filter.
NOTE:
B Be sure to install the air filter
cover before using the projector.
If the projector is used without the
air filter cover installed, dust and
other foreign particles will be
drawn into the projector, and
malfunctions will result.
B If the dust cannot be removed by
cleaning, it is time to replace the
air filter. Please consult your
dealer. Furthermore, if the lamp
unit is being replaced, replace the
air filter at this time also.
E -53
NGLISH