Accessories; Accessories Supply; Remote Control Batteries - Panasonic TH-85PF12E Operating Instructions Manual

Accessories

Accessories Supply

Check that you have the accessories and items shown
Operating CD-ROM
Instruction (Operating
book instructions)
Ferrite core × 2
Use the Ferrite cores and Noise cut fi lter to
comply with the EMC standard. (see page
59)

Remote Control Batteries

Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
Remote Control
Transmitter
EUR7636090R
Clamper × 1
Noise cut fi lter
Use the clamper
when connecting a
LAN cable.
(see page 59)
2. Insert batteries - note correct
polarity ( + and -).
+
-
+
"R6 (UM3)" size
Batteries for Power supply
the Remote cord
Control
Transmitter
(R6(UM3) Size
× 2)
Eyebolt cap × 1
Blind sheet × 1
3. Replace the cover.
-
Fixing band
× 2
Eyebolt × 1
(M12)
Allen wrench
7