Using Network Function; Example Of Network Connection; Command Control - Panasonic TH-85PF12E Operating Instructions Manual

Using Network Function

This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each "Network Setup" setting and make sure to set the "Control I/F Select" to "LAN".
(see page 53)
When "LAN" is set, the slot power is turned on, and power indicator is lit orange under the condition of power "Off" with
remote control (stand-by state), regardless of the "Slot power" setting. (see page 56)

Example of Network Connection

COMPUTER
LAN cable
(not supplied)
Ferrite core
(supplied)
Less
than
10 cm
Hub or broadband router
Notes:
• Lay the LAN cable away from other connection cables (excluding the power cord).
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use "category 5" LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
Securing the LAN cable
When using a pedestal (TY-ST85P12) for the installation of the display, use a clamper supplied
with the display to secure the LAN cable. For use with another method of installation, refer to
the corresponding Installation Instructions.
Clamper
Note: In accordance with the Installation Instructions, secure the LAN cable so that it will not become near the
display unit.

Command Control

Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 10)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Less
than
10 cm
Ferrite core Noise cut fi lter
(supplied) (supplied)
Installing the Ferrite core
Pull back the tabs
(in two places)
Display (main unit, rear)
AUDIO
P /C /R P /C /B Y/G
R R B B
LAN COMPONENT/RGB IN
SLOT3
Open
Wind the cable twice Press the cable through
and close
59