Recording On A Tape - Panasonic NV-GS80EP Operating Instructions Manual

LSQT1130_ENG.book 20 ページ ２００６年１２月１６日 土曜日 午後８時４５分
ª Recording mode
You can switch the tape recording mode.
≥Set to Tape Recording Mode.
1
Set [BASIC] >> [REC SPEED] >> [SP] or
[LP].
If the LP mode is selected, the recording time will
be 1.5 times the SP mode, but some functions will
be disabled.
≥We recommend using the SP mode for
important recording.
≥In order to fully exhibit the performances of the
LP mode, we recommend using Panasonic
cassettes marked LP mode.
≥In the LP mode, the picture quality will not be
degraded in comparison with the SP mode, but
mosaic noise may appear on the playback
image or some functions may be disabled.
≥Playback on other digital video equipment
or on digital video equipment without the LP
mode.
≥Playback of the image on other digital video
equipment recorded in the LP mode.
≥Frame-by-frame playback.
20
LSQT1130
Record mode

Recording on a tape

Remove the lens cap. (
(When the camera is turned on with the lens
cap fitted, the automatic white balance
adjustment may not function properly. Please
turn the camera on after removing the lens
cap.)
When this unit is purchased, the aspect ratio is
set to [16:9] for recording images compatible with
a wide-screen TV. To make this unit compatible
with regular TVs (4:3), change the
[REC ASPECT] setting before recording the
images ( ) or change the [TV ASPECT] setting
-27-
when watching them on the connected TV (
≥Set to Tape Recording Mode.
1
Press the recording start/stop button to
start recording.
2
Press the recording start/stop button again
to pause recording.
≥For the recording time on a tape, refer to
≥Carry out a recording check (
the image is recorded properly.
≥In order to find the unrecorded section, carry out
the blank search (
)
-7-
-33-
;
.
-10-
) to verify that
-21-
).
-22-
).