Manual Shutter Speed/Aperture Adjustment - Panasonic NV-GS80EB Operating Instructions Manual

LSQT1131_ENG.book 30 ページ ２００７年１月１１日 木曜日 午前９時５分
Manual shutter speed/aperture
adjustment
Shutter Speed
Adjust it when recording fast-moving subjects.
Aperture
Adjust it when the screen is too bright or too dark.
≥Set to Tape Recording Mode.
1
Set the [AUTO/MANUAL/FOCUS] switch to
[MANUAL].
2
Move the joystick left or right to select the
shutter aperture icon [
icon [ ].
MNL
3
Move the joystick left or right in order to
adjust the shutter speed or aperture.
MNL
1/50
OPEN
OdB
1 ) 2
MNL
1/1000
1) Shutter speed
2) (Aperture) Iris/gain value
ª
To restore to automatic adjustment
Set the [AUTO/MANUAL/FOCUS] switch to
[AUTO].
30
LSQT1131
Record mode
] or shutter speed
)
MNL
1/50
F2.0
0dB
Manual shutter speed adjustment
≥Avoid recording under fluorescent light, mercury
light or sodium light because the colour and
brightness of the playback image may change.
≥If you increase the shutter speed manually, the
sensitivity lowers and accordingly the gain value
increases automatically, which may increase
the noises on the screen.
≥You may see vertical lines of light in the
playback image of a brightly shining subject or
highly reflective subject, but this is not a
malfunction.
≥During normal playback, image movement may
not look smooth.
≥When recording in the extremely bright place,
the colour of the screen may change or flickers.
If so, adjust the shutter speed manually to 1/50
or 1/100.
Manual iris/gain adjustment
≥Set the shutter speed before setting the
aperture (iris/gain) when manually adjusting
both settings.
≥If the value does not become "OPEN", you
cannot adjust the gain value.
≥If the gain value is increased, the noise on the
screen increases.
≥Depending on the zoom magnification, there are
iris values that are not displayed.
ª Shutter speed range
1/50–1/8000 seconds: Tape Recording Mode
The shutter speed closer to 1/8000 is faster.
ª
Iris/gain value range
CLOSE (Closed), F16, ..., F2.0,
OPEN (Opened: F1.8) 0dB, ..., 18dB
Value closer to [CLOSE] darken the image.
Value closer to [18dB] brighten the image.
Values with dB are gain values.