Step 1 Connection - Panasonic Diga DMR-EH545 Operating Instructions Manual

1
STEP
Using a 21-pin Scart cable
≥You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television (
≥You can enjoy high-quality viewing by connecting the unit to an RGB compatible television (
"AV1 Output" in the Setup menu (
Required setting
≥Before connection, turn off all equipment and read the appropriate operating instructions.
≥Select the connection pattern that matches your environment from pattern A–B. Confirm connections not listed below with your
dealer.
≥Refer to "Additional connections" (
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket. This unit consumes a small amount of power, even when it is turned off
[Approx. 0.3 W ("Power Save in Standby" is activated and "RF OUT ( Aerial Signal )" is set to "Off".)]
A
Connecting a television
To the aerial
Aerial cable
RF coaxial
cable
2
1 2 (supplied)
B
Connecting a television and digital/satellite receiver or decoder
To the aerial
Aerial
cable
RF coaxial cable
(supplied)
2
1 2
RF
IN
RF
OUT
Digital/satellite receiver
or decoder's rear panel
Required setting
"AV2 Input" and "AV2 Connection" settings in the
Setup menu (
VQT3N81
8
Connection
71) for connection using other terminals and connection with other equipment.
Television's rear panel
VHF/UHF
RF IN
RF
IN
RF
OUT
Television's rear panel
VHF/UHF
AV
RF IN
(DECODER/EXT)
21-pin Scart cable
AV
68)
67)
Connecting a terminal other
AV
than the 21-pin Scart terminal
( 9)
3
Fully wired 21-pin
Scart cable
AV1
(TV)
AV2
(DECODER/EXT)
Connecting a terminal other
than the 21-pin Scart terminal
( 9)
3
Fully wired 21-pin
Scart cable
Cooling fan
AV1
(TV)
OPTICAL
AV2
Connect the unit directly to the television
4
If you connect the unit through an AV selector
or video cassette recorder to the television,
video signal will be affected by copyright
protection systems and the picture may not
be shown correctly.
≥When connecting to a television with a built-in VCR
Connect to the input terminals on the television side if there are
both television and VCR input terminals.
40).
82).
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(supplied)
Connect only after all other
connections are complete.
Cooling fan
OPTICAL
This unit's rear panel
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(supplied)
Connect only after all other
connections are complete.
This unit's rear panel
4
AC IN
5
AC IN
DO NOT
Television
VCR
This unit