Panasonic Diga DMR-XS385 Operating Instructions Manual page 89

U50
The terminal, antenna cable or dish is short-circuited as
for both LNB IN 1 and LNB IN 2. Check the connection
status. ( 14)
U50 1
The terminal, antenna cable or dish is short-circuited as
for LNB IN 1. Check the connection status. (
U50 2
The terminal, antenna cable or dish is short-circuited as
for LNB IN 2. Check the connection status. (
U59
The unit is hot.
The unit switches to standby for safety reasons. Wait for
about 30 minutes until the message disappears.
Select a position with good ventilation when installing the
unit. Do not block the cooling fan on the rear of the unit.
U61
(When a disc is not inserted) Displays when a
malfunction has occurred. This is displayed when the unit
is in the recovery process to return to normal operation.
Once the display clears you can use the unit again.
If it remains displayed, consult the dealer where the unit
was purchased.
U76
HDMI cannot be output because it is connected to a
model that does not support copyright protection.
U77
Due to the current disc not having authorised copyright
information, video output is not performed.
U88
(When a disc is inserted) Displays when there was
something unusual detected with the disc while
recording, playback or copy. This is displayed when the
unit is in the recovery process to return to normal
operation. Once the display clears you can use the unit
again.
If it remains displayed, consult the dealer where the unit
14)
was purchased.
U99
The unit fails to operate properly. Press [Í/I] on the main
14)
unit to switch the unit to standby mode. Now press [Í/I]
on the main unit again to turn the unit on.
H or F
("∑" stands for a number.)
There is something unusual. (The service number
displayed after H and F depends on the unit's condition.)
Check the unit using the troubleshooting guide. (
95) If the service number does not disappear, do the
following.
1. Disconnect the plug from the household mains socket,
wait a few seconds, then reconnect it.
2. Press [Í/I] to turn the power on. (The unit may be fixed.)
If the service number does not disappear despite after doing
the above, request service from the dealer. Inform the dealer
of the service number when requesting service.
X HOLD
The HOLD function is activated.
Press and hold [OK] and [RETURN
until "X HOLD" disappears. (
90–
] at the same time
87)
89
VQT2J59