Software (Firmware) Update - Panasonic Diga DMR-PWT420 Operating Instructions Manual

Convenient functions

Software (Firmware) Update

You cannot operate the unit until the update
is complete. Don't remove the AC mains lead
during the update. Removing the AC mains
lead while the update is in progress may
damage the unit.
Software of this unit can be updated automatically
by the following methods at the specified time.
(Default setting is 3 a.m.
in Standby)
- From broadcasts
- From Internet
§
• To update the software (Firmware) immediately,
use the following function:
- Software Update Now ( Broadcast ):
Software of this unit will be updated from
broadcasts if update information is detected.
- Software Update Now ( Internet )
Software of this unit will be updated from
Internet if update information is detected.
Network connection and setting are required.
§
( 16, 21)
84
VQT4E90
82, Software Update
:
§
If a software (firmware) update is available, a
notification is displayed.
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
Update of the software (firmware) will start when
the unit is turned to standby mode.
The unit's display during the update
e.g.,
• When "FINISH" is displayed, update of the
software (firmware) has completed.
• It may take up to a few hours until the update is completed
depending on the network or broadcast environment.
• The timer recording always takes preference over the
software (Firmware) download; if the timer recording is
scheduled to start, the downloading will be performed at the
next opportunity.
• You can also download the latest software (firmware) from
the following website.
http://panasonic.jp/support/global/cs/