Honeywell EQUIP HD4HDIH User Manual page 4

Revisions
Issue Date
V1 RevA 11/2011
V2 RevA 11/2011
4
Revisions
New version of the User Guide for the HD4MDIH(X) camera, with HD4HDI(X) and
HD4MWIH(X). Replaces 800-07496 Rev B.
Corrected Video Compression settings in the Specifications. Added a note advising
that the camera should not be connected to two different power sources at the same
time. Added a note in the Installation section advising that the housing is intended for
installing on a flat surface. Added an additional step describing the use of rubber
washers with screws other than those supplied by Honeywell. Changed how many
Administrators/Guests can be logged on at the same time. Changed the length of time
to hold down the system reset button to restore the camera to factory defaults. Added
a FAQ suggesting that antivirus software should be disabled before installing the IP
Utility software. Added an illustration that shows how to hold the dome bubble in front
of the lens for lens adjustment.
Also added the information for installing the Honeywell IP Utility on Windows 7. And
added Frame Rate to the list of available priority settings in the Compression Settings
section.
Added information about the Mechanical Zoom and Focus functions for HD4HDIH(X).
Removed a sentence in Specifications which states that only 4 users can log on at a
time. Removed notes throughout that referred to a limited number of users that can
be logged on at a time. Updated the System Requirements. Added the step for
Enabling Microsoft .NET Framework 3.5 to the Install Honeywell IP Utility Software
section. Expanded on the Disable User Account Control section. Added WDR and
LDC to the Auto Exposure Settings table. Changed the Immunity Regulatory
specification from EN 50024 to 50130-4.