Connection - Panasonic RX-VT80 Operating Instructions Manual

Connection

Connect the AC power supply cord only after all other connections
have been made.
Preparation
• Be sure to set [SELECTOR] to TAPE/
1
Speaker cords
1
2
3
R
R S (I M P
S P E A K E
When connecting the
car battery cord
(not included)
DC IN
(12-13.2V)
Disconnect the AC power
supply cord.
Insert the plug into the DC IN
Jack.
Plug the other end into the
cigarette lighter socket in
your car.
4
RQT7801
.
OPR OFF
To TV
Red (+)
Black (–)
L
Black (–)
4 Ω )
Red (+)
4
AC power supply cord
Appliance
inlet
Connector
Insertion of connector
Even when the connector is perfectly
inserted, depending on the type of inlet
1
used, the front part of the connector may
jut out as shown in the drawing.
There is however no problem using the
unit.
Note
The included AC power supply cord is for
2 use with this unit only.
Do not use it with other equipment.
2
Video connection cable
Connect the video connection cable
from the VIDEO OUT terminal of the
rear panel of this unit to the VIDEO
IN terminal of the TV.
Set the VIDEO SWITCH to match
the television set to be connected.
PAL : When connecting to a PAL
system TV.
NTSC : When connecting to a NTSC
system TV.
For details, refer to the TV operating
instructions.
3
Set the voltage
Use a flat-head screwdriver to turn the
voltage selector on the rear panel to the
appropriate position for the area in which
this system is to be
used.
(included)
When using batteries
Approx.
6 mm
Insert batteries in numbered order.
6
3 5
2
Disconnect the AC power supply cord.
Replace the batteries when
OPERATION/BATT goes dim during play.
OPERATION/BATT
Removal
Insert your finger into the slot (
bottom of the unit and push out the
batteries.
(included)
VIDEO
OUT
VIDEO
SWITCH
PAL NTSC
220- 220-
240V 240V
110- 110-
127V 127V
110-127V 220-240V
To household
AC outlet
(not included)
7
R20/LR20, UM-1
4
1
OPERATION / BATT
a
) at the
a