Safety Instructions - Miele KM 360 G Installation Instructions Manual

Building in
Fit wall units and extractor hood
before fitting the hob, to avoid
damaging the appliance.
The veneer or laminate coating of
worktops (or adjacent kitchen
units) must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
Ideally the gas hob should be
installed with plenty of space on
either side. There may be a wall at the
rear and a tall unit or wall at one side.
On the other side, however, no unit or
divider should stand higher than the
hob (see illustrations).
This equipment is not designed for
maritime use or for use in mobile
installations such as caravans, aircraft
etc. However it may be suitable for
such usage, subject to a risk
assessment of the installation being
carried out by a suitably qualified
engineer.
Due to the heat radiated by the hob
and to allow cooking fumes to
dissipate, it is essential that a
minimum safety distance a of 100
mm is maintained between the
worktop cut-out and adjacent
furniture, e.g. a tall unit.

Safety instructions

recommended
not recommended
not allowed
5