Cassettes - Panasonic RX-ED50A Operating Instructions Manual

14
RQT5142
Displayed when cassette not loaded.
Tape facing out
Insert inside the guides
Selected deck
Play direction
Tape counter

Cassettes

You can play cassettes in either deck 1 or deck 2. Deck
1 is used in this example.
Preparation: (when using batteries) Press [
Press [ TAPE/CD] to switch to TAPE
mode.
(Unit comes on when using AC power.)
Press [ DECK 1] to open the deck and
load a cassette.
Play starts from the side facing up
Close deck by hand.
(Play direction automatically switches to "
deck is closed.)
Press [
: Side facing up played
: Side facing down played
Press [–,+VOLUME] to adjust the volume.
To stop play
Press [ TAPE/CD].
One touch play (When using AC power)
When a cassette is loaded, press [
The unit comes on and play starts.
To change sides
Press [ ] during play.
Each time the button is pressed
Fast-forward and rewind
While stopped
Press [ REW–TUNE/
TUNE/ –FF] (forward).
Cassette tape selection and care
The unit can play normal, high, and metal position tapes. It
identifies the type automatically.
•Tapes exceeding 100 minutes are thin and can break or
get caught in the mechanism.
•Tape slack can get caught up in the mechanism and should
be taken up before the tape is played.
•Endless tapes can get caught up in the deck's moving
parts if used incorrectly. Use tapes appropriate to this unit's
auto-reverse mechanism.
].
" when the
] to start play.
].
] (backward) or [