Cassettes - Panasonic SC-AK330 Operating Instructions Manual

Cd stereo system model no. sc-ak330; sc-ak230
Hide thumbs Also See for SC-AK330:
Table of Contents

Advertisement

Optional antenna connections
Use outdoor antenna if radio reception is poor.
Note
Disconnect the outdoor antenna when the unit is not in use. Do not use the outdoor antenna during a lightning storm.
FM outdoor antenna
For Europe
Rear panel
of this unit
For others
Rear panel
of this unit
1
2
Disconnect the FM indoor antenna.
The antenna should be installed by a competent technician.

Cassettes

Playback
You can use either deck 1 or deck 2 for tape playback.
Use normal position tapes.
High position and metal position tapes can be played, but the unit will
not be able to do full justice to the characteristics of these tapes.
Your attention is drawn to the fact that recording pre-recorded
tapes or discs or other published or broadcast material may infringe
copyright laws.
1
Press [:, TAPE].
The unit comes on.
If a cassette was loaded, play starts automatically (One touch play).
2
Press [c DECK1] or [DECK2 c] and insert the cassette.
Insert with the side to be played facing
towards you and the exposed tape facing
down. Close the holder by hand.
Recording
Selection of tapes for recording
Use normal position tapes.
High position and metal position tapes can be used, but this unit will
not be able to record or erase them correctly.
Preparation:
Wind up the leader tape so recording can begin immediately.
1
Press [DECK2 c] and insert the cassette to be
recorded.
Insert with the side to be recorded facing towards you and the
exposed tape facing down.
2
Select the source to be recorded.
Radio recording:
Tune in the station. (A page 10)
Disc recording:
1 Insert the disc(s) you want to record.
Press [:/J, CD] and then [L, STOP].
2 Prepare the desired disc recording mode.
Remote control only
To record programmed tracks
On page 8, "Program play", do steps:
1 ~ 3
CD
1 ~ 4
MP3
To record specific discs/tracks
1. Press [PLAY MODE] to select the desired mode.
(A page 7)
2. Press [DISC] and then [1]–[5] to select the disc.
Ensure disc is stopped.
3.
MP3
For 1-ALBUM mode and 1-SONG mode: Press
[ALBUM (
or
)] to select the album.
4. For 1-SONG mode: Press [g, REW/3] or [f,
4/FF] to select the track.
FM outdoor antenna
(not included)
75 Ω coaxial cable
(not included)
For the United Kingdom
Antenna plug adaptor
(included)
1
30 mm
2
Shield braid
15 mm
Core wire
3
Front
side
AM outdoor antenna
AM outdoor antenna (not included)
For Europe
1
Rear panel
of this unit
2
For others
1
Rear panel
2
of this unit
Run a piece of vinyl wire horizontally across a window or other
convenient location.
Leave the loop antenna connected.
3
Press [:, TAPE] to start playback.
To play on the other side of the tape, turn the tape over and press
[:, TAPE].
To stop tape playback
Press [L, STOP].
To fast-forward or rewind
Press [g/REW/3] (rewind) or [f/FF/4] (fast-forward).
To select between loaded decks
Press [DECK 1/2] (remote control: [PLAY MODE]).
Note
Tape playback is momentarily interrupted if you open the other deck.
Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
Tape slack can get caught up in the mechanism and should be
taken up before the tape is played.
Endless tapes can get caught up in the deck's moving parts if used
incorrectly.
Tape-to-tape recording:
1 Press [:, TAPE] and then [L, STOP].
2 Press [c DECK1] and insert the cassette you want to record.
3
Press [a, REC] to start recording.
To stop recording
Press [L, STOP].
If the tape finishes before the disc
The disc continues playing. Press [L, STOP] to stop it.
To record on the other side of the tape
Turn the tape over and press [a, REC].
Note
Changes to volume and sound/field quality do not affect recording.
You cannot open deck 1 while recording.
You cannot fast-forward or rewind one deck while recording with
the other.
When recording an AM broadcast, sound is momentarily interrupted
when you start and stop the recording.
Erasure prevention
Use a screwdriver or similar
object to break out the tab.
Tab for side B
To re-record on a protected cassette
Cover the hole with adhesive tape.
To erase a tape
1. Press [:, TAPE] and then [L, STOP].
2. Insert the recorded tape into deck 2.
Ensure there is no tape in deck 1.
3. Press [a, REC].
5 -12 m
AM loop
antenna
(included)
Side A
Tab for side A
Adhesive tape
11
RQT7796

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc-ak230Sa-ak330Sa-ak230Sb-ak330Sb-ak230

Table of Contents