FAQs
Problem
Problem
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
Unable to receive
signals with a
high-performance
aerial
Sound is unusual
An error message
appears
"Control with HDMI"
function does not work
The SD card cannot
be used even when it
is formatted
TV unit goes into
"Standby mode"
An error message
appears
44
Actions
Actions
•
Install an aerial individually for the TV unit and VCR
(or use a splitter).
TV
(Individual aerial)
Splitter
Aerial Output
Aerial
Input
Aerial Input
Aerial Output
terminal
VCR
(Individual aerial)
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu.
(p. 16)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 38)
•
Contact the authorized Service Centre.
•
Switch the TV unit on again with the equipment on.
•
Set "Control with HDMI" to "Off", then set to "On" again.
(p. 31)
•
Contact the authorized Service Centre.
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min.
after broadcasting ends.
•
Follow the message's instructions.
•
If the problem persists, contact the authorized
Service Centre.
SD Card: On screen messages
Message
•
Is SD Card in?
Insert a SD card.
•
SD Card is locked
Unlock the SD card.
Please unlock to operate
•
This fi le is locked
Unlock the fi le in the card.
Please unlock to operate
•
This type of format is not
The unit does not support the format.
supported
(For the applicable formats and data, see p. 40.)
•
This type of card is not
A card not supported by the unit has been inserted.
supported
(For the supported cards, see p. 40.)
•
Broken fi le
The fi le is broken.
Cannot display image
•
Memory full
The card memory is full.
•
Not enough memory
The card does not have enough memory to operate.
•
Cannot read fi le
The fi le is not readable.
•
Unrecordable source
That channel cannot be recorded.
SD recording is stopped
(Recording is automatically stopped.)
•
Error
Re-insert the card. If the error persists, format the card. (p. 29)
Check card
•
Card recording in progress
That operation is not available during recording.
Please stop recording to operate
To continue the operation, stop recording.
(For example, changing channels while recording a TV
programme.)
•
Delete fi le?
Displayed when you press Red colour button to delete a
MPEG4 fi le. Press OK button to confi rm deleting.
•
No time data
Since the signal does not have the time information, the date is
Cannot store time info
recorded as 01/01/2000.
Cautions in handling SD Card :
•
Do not remove the card while the unit is accessing data ("blue" LED
On) (this can damage card or unit).
•
Do not touch the pins on the back of the card.
•
Do not subject the card to a high pressure or impact.
•
Insert the card in the correct direction (otherwise, card may be
damaged).
•
Electrical interference, static electricity, or erroneous operation may
damage the data or card.
•
Back up the recorded data at regular intervals in case of deteriorated
or damaged data or erratic operation of the unit. (Panasonic is not
liable for any deterioration or damage of recorded data.)
Meaning/Action
Blue LED
WARNING: As with an small object,
SD card can be swallowed by young
children. Do not allow children to
handle SD card. Please remove SD card
immediately after use.
45