Table of Contents
Advertisement
Components
The images shown in this wall mounting installation instructions are for illustrative purpose only.
Check the supplied components before starting.
∏ 2 Wall mount brackets
(RYQX1034-K)
∏ 2 Lock pins
(RYQX1048)
Commercially available components (not supplied)
≥ Screws for wall mounting
≥ Fall prevention cord
≥ Use commercially available screws with a nominal diameter of ‰4.0 mm that are suited to the wall material
(wood, steel frame, concrete etc.) you are attaching the wall mount brackets to.
≥ Product numbers correct as of April 2010. These may be subject to change.
Installation procedure
Never use any other method than specified to install
Attaching the wall mount brackets
Preparation
≥ To prevent damage or scratches, lay down a
soft cloth and perform the assembly on it.
≥ Do not hold this unit in one hand to avoid injury by dropping this unit when carrying.
1
On the rear of the unit:
Place the wall mount bracket by
aligning the holes in the wall mount
bracket with the projecting parts A.
2
Screw the wall mount bracket firmly
into place.
≥ Screw tightening torque: 80 N0cm to
120 N0cm.
≥ Repeat the steps above when installing the
second wall mount bracket.
22
∏ 1 AC mains lead
(RFAX1027C)
≥ Screws to attach fall prevention cord to wall
≥ Keep the screws out of reach of children to
prevent swallowing.
∏ 2 Screws
(RYQX1042-1)
Hide quick links:
Advertisement
Table of Contents
